How to Achieve the Best Decorative Concrete
Stamped concrete can be a beautiful addition to any property. However, this needs to be given utmost attention and care because if you do it badly, your property will look unsightly. During the process of stamping, it is vital that there are no spots left unattended to because these issues will only be noticed after the process is all done. The best contractors have already learned from their mistakes and have seen all these scenarios. There are several tricks that will help achieve better texture and they are listed below. Stamping early is one of the things that you must do. Stamping early means all you will need to do is walk on the stamps on the surface for you to get the results that you want.
You can also use retarders when stamping so that you reduce the rate of evaporation. It is possible to assume that the slab has already become hard enough just because you can see that it has crusted. Once you start stamping, you will find yourself sinking even deeper and this way the crust will crack. There is need to apply the evaporation retarder so that the top dries well. The evaporation is going to be slowed down when you apply the retarder and the texture on the slab will be excellent.
The next step is to make sure that the slab is crawled. All you need to do is send a few people out on kneeboards just before the stamping begins. The weight and the vigorous floating of the slab will work the surface up. You will get the same consistency throughout the slab and this will enable stamping be easier. This is the simplest way to achieve the results you want dramatically. You can always save the situation by rolling the surface especially if the slab starts to get ahead of you. Texture is easily gotten like this.
You can wear textured shoes as great tools for you to stamp the slab. Do not expect any straps or buckles on stamping shoes and they use friction to be held in place. You will easily walk over the concrete without sinking since the weight of the wearer spreads over a large area. Starting in the middle moving out is the best way to approach the stamping situation. Stamping will be more uniform this way and you will not have the problem of different textures on opposite ends of the slab. You will get the consistency you want but only if you use more stamps than usual and this is the one thing you need to note about this technique.